UPS & critical power
We install and maintain uninterruptible power systems of every size. Independent of any one manufacturer, we match the right system to your load and keep it running.
- Mains Healthy
- Battery Standby
- Load Protected
Qualified for UPS work
UPS and battery systems need specialist training, not just a general electrical ticket. These UPS-specific qualifications are held within our team, with our UPS work led by Managing Director Mark Fowler.
-
Switching and Safe Isolation of UPS Systems
Safe switching, isolation and bypass procedures on live UPS installations.
-
Standby Battery System Installation
Installing UPS and standby battery strings, cabinets and racks.
-
Operational Health and Safety Awareness for Standby Battery Systems
Working safely around standby battery systems: hazards, handling and controls.
Alongside NICEIC Approved Contractor status, ECS cards and SparkSafe Licence to Practice.
Any size, any brand
Because we are not tied to any UPS manufacturer, we are free to recommend the system that suits your site. We install and maintain systems from all the major brands, at any scale.
Comms rooms and server cabinets
Rack-mounted and single-phase units protecting network kit, phone systems and small server rooms.
Commercial buildings
Three-phase standalone systems for offices, schools, labs and critical floor areas.
Data centres and hospitals
Large and modular systems, including parallel and redundant configurations for loads that can never drop.
What we install and look after
- UPS installation and commissioning support
- Positioning, cabling and connection of new systems, working with the manufacturer's engineers through commissioning.
- Battery systems and replacements
- Battery strings, cabinets and racks installed or replaced, with safe disposal of old cells.
- Maintenance bypass panels
- External bypass arrangements so the UPS can be serviced or replaced without dropping the load.
- Generator interface and ATS changeover
- Changeover switching and controls so the UPS, mains and standby generator work together.
- LV supplies and distribution
- Incoming supplies, sub-mains, distribution boards and final circuits feeding and fed by the UPS.
- Replacements and upgrades
- Swapping out end-of-life systems on live sites, planned around your operation.
How a UPS install runs
Survey
We look at the load, the space, the supply and how the site operates day to day.
Specify
We size the system, the batteries and the bypass arrangement, working alongside the chosen manufacturer.
Plan the shutdown
Method statements, isolation plans and timings agreed so the live operation is protected.
Install and commission
Our electricians install and connect, then support the manufacturer through commissioning.
Maintain
A maintenance contract keeps the system tested and ready, year after year.
Maintenance contracts
A UPS only protects you if it works on the day the mains fails. Our maintenance contracts cover the electrical side of your system so problems are found on a planned visit, not during an outage.
- Planned maintenance visits
- Battery testing and replacement
- Bypass and changeover checks
- Thermal and connection checks
- Coordination with manufacturer servicing
- Clear reports after every visit
UPS questions
Which UPS brands do you work with?
All the major manufacturers. We are independent rather than tied to one brand, so the recommendation is based on your site.
Can you install a UPS without shutting the site down?
Most of the work can be done with the site live. Where a shutdown is needed for the final connection, we plan it with you, usually out of hours, and keep it as short as possible.
Do you take on maintenance for a UPS someone else installed?
Yes. We will survey the existing system and set up a maintenance contract that suits it.
Planning a UPS install?
Tell us about the site, the system or the people you need. We will come back to you within one working day.